Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

WAN load balancing

Two sales office connected through point-to-point leased line (2Mbps).

The management is upgrading the link with a second leased line (also 2Mbps).

In each office I am installing a Router with WIC-2T.

Can I configure the Routers to use both the lines in load-balancing, or can I have just a "primary" link and a BackUp link?

Best Regards

Claudio

2 REPLIES
Hall of Fame Super Gold

Re: WAN load balancing

As long routing is set correctly, it wil load balance.

If you need speed faster than 2mbps for a single session, configure MLPPP.

Blue

Re: WAN load balancing

Caludio:

I dont know where you're located or the availability of the service, but you may want to look at a metro-E connection of 10mbps. It may come out more cost effective and give you bandwidth for growth. You also wont have to pay for more facilities at your office.

Just a suggestion...

Victor

130
Views
0
Helpful
2
Replies
CreatePlease to create content