cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
322
Views
0
Helpful
1
Replies

WAN PIM Sparse-Mode

specialed351
Level 1
Level 1

I am trying to route multicast packets over a WAN. through a 6509 to a 3750. Both routing. the 6509 is routing dense mode to the local lan and sparse mode to the WAN. (please see the mroute output for the 6509 below)

the source for the group is directly connected to the 6509.

(*, 239.0.1.1), 01:03:46/stopped, RP 10.1.255.1, flags: DC

Incoming interface: Null, RPF nbr 0.0.0.0

Outgoing interface list:

Vlan22, Forward/Dense, 01:03:46/00:00:00

Vlan24, Forward/Dense, 01:03:46/00:00:00

(10.1.2.19, 239.0.1.1), 01:03:46/00:02:56, flags: T

Incoming interface: Vlan2, RPF nbr 0.0.0.0, RPF-MFD

Outgoing interface list:

Vlan24, Forward/Dense, 01:03:46/00:00:00, H

Vlan22, Forward/Dense, 01:03:46/00:00:00, H

the 3750 is pulling through sparse mode, but never seems to register with the RP and therefore flow data:

(*, 239.0.1.1), 03:24:45/00:02:56, RP 10.1.255.1, flags: SJC

Incoming interface: Null, RPF nbr 0.0.0.0

Outgoing interface list:

Vlan521, Forward/Sparse, 01:59:11/00:02:56

also note the "sh ip mroute count" output and how the packets are all in "Other".

Group: 239.0.1.1, Source count: 0, Packets forwarded: 0, Packets received: 417321

RP-tree: Forwarding: 0/0/0/0, Other: 417321/0/417321

Can any one help?

Thanks,

Ed

1 Reply 1

ivillegas
Level 6
Level 6

Did you enable multicast routing in the 3750?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card