Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WAN Routing: Lease Line

I have 3 x 1841 routers.

Head Office

Router A: LAN IP: 192.168.1.1/24

Router B: LAN IP: 192.168.1.10/24

These two are connected via Cisco switch.

Branch Office

Router C connected via Lease Line (Serial Port) to Router B.LAN IP: 192.168.3.1.

Router C only knows Router B. All traffic out is forwarded to that router. Router A is the main one that has all thr routes to other networks configured.

How to configure routing such that:

1. All traffic from Router C is forwarded to Router A.

2. On Router A, what config to enter to route to 192.168.3.x network.

Thx

4 REPLIES
Hall of Fame Super Silver

Re: WAN Routing: Lease Line

roghen

If router C has only 1 external connection and it is to router B then router C probably should have a default route configured which point to router B. It should look something like:

ip route 0.0.0.0 0.0.0.0

On router A you would want a route to the LAN of C which would probably be:

ip route 192.168.3.0 255.255.255.0 192.168.1.10

HTH

Rick

New Member

Re: WAN Routing: Lease Line

it sounds logical.

perhaps there should be another route on Router B :

ip route 0.0.0.0 0.0.0.0

any confirmation?

Hall of Fame Super Silver

Re: WAN Routing: Lease Line

roghen

Yes that does sound logical. I assumed from your original post that it probably already did exist. If your comment that router A has routes for most networks then it is logical that router B and router C should have default routes pointed to router A.

HTH

Rick

New Member

Re: WAN Routing: Lease Line

thx buddy.

will test it out and see how it goes

291
Views
0
Helpful
4
Replies