Hello all, my name is Bernardo, and I'm a newbie to the Cisco world. I have been tasked with connecting our DR location with our Primary location over a WAN. Currently, the two locations are connected via a metro-e.
I have two routers available to get this task done (a 2621 and 3600). Will I need WIC's to get this task done? What's the best way to get this task done with the two routers I have available. Thanks for any advice.
If you have a T1, then you need a WIC-1DSU-T1 on each router. The default settings on this card should get you going and all you need to do is apply the ip address under the serial interface at each device and if the T1 has been provisioned by the service provider, you should be able to ping between the devices.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...