Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WAN setup 1600 series

Hi,

A dummy question I am sure. Kindness appreciated.

A client has been having difficulty in channelized T1 going from 6 to 12 B channels. Their interface is serial connected to a CSU. If the encapsulation remains the same are there any configuration changes needed to the router?

Thanks for any helop in advance.

Jim C

2 REPLIES
Cisco Employee

Re: WAN setup 1600 series

Jim,

There are two main things that you have to take care:

1. T1 controller settings has to be same both at the HO router and BO routers. Make sure that the controllers setting are exactly the same and as per the ISP info like Framing and line coding.

2. Make sure that the encap and the oher ip address related configuration is same at both the ends.

HTH,

-amit singh

New Member

Re: WAN setup 1600 series

If there is an external CSU/DSU are there any controller settings on the router? The CSU/DSU sets up the channels and clocking, correct? Are their any channel specific configs at the router acting as DTE?

101
Views
0
Helpful
2
Replies
CreatePlease login to create content