"What technology should i practice most on my home lab so that i know what to say in the interview cause i dont have any experience except the CCNA certification..."
Anyway, ATM, Frame Relay, MPLS, MetroEthernet, etc, are all used extensively. If you really want to practice with different technologies, I suggest you configure a lab setup for each one of them one at a time...
I believe there are CCNA network Simulators out there that do just that. They run you about $150 or so. Check it out...
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...