WAP121 Wireless-N Access Point with Single Point Setup
Ive bought the above AP.
I can't make the AP to forward a local ip from my router. normal my setup is inet -> router -> ap.
Ap recieves an local ip 192.168.1.XX from router. Ive used the setup Wizard. dhcp/no single point/named the ssid.
I can see the network created by AP, but my devices can not acccess the network. I can see on my wifi devices that they recived a random ip 184.108.40.206, so its like the AP doesnt forward an ip from my router.
Can you assist what could be done wrong during setup
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...