Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WCCP Direction IN and OUT

Hi, I am confused with WCCP direction. I have L3 switch. Content device is attached on E0/0 & desktops are connected on other interfaces,like e0/2, e0/3. Please help me about commmand "IP WCCP Web Redirect OUT/IN". IN direction will on E0/0 where Content device is connected or any other logic ?

3 REPLIES
New Member

Re: WCCP Direction IN and OUT

rupesh

Since the redirection is local on the switch itself you should need the following commands

ip wccp web-cache (enable web-caching)

under the e0/0 interface you will need the following command

ip wccp web-cache redirect in

If the content device was external (across the MPLS, ect) than you would redirect outbound. Hope this helps

New Member

Re: WCCP Direction IN and OUT

Any command for sw ports where desktops are connected ?

New Member

Re: WCCP Direction IN and OUT

no, that should be all you need. And you are just wanting to use this for web caching correct? Because we use it for port-redirection for Riverbed traffic to optimize..

158
Views
5
Helpful
3
Replies