Jan 22 18:48:26.326: %FMANRP_ESS-4-FULLVAI: Session creation failed due to Full Virtual-Access Interfaces not being supported. Check that all applied Virtual-Template and RADIUS features support Virtual-Access sub-interfaces. swidb= 0x7FFDA39236F8, ifnum= 41
The "%IOSXE_WCCP-4-NOINTF: No Virtual-Template1 interface info for Service Group (1, 80, 0)" notification is due to a cosmetic bug CSCtc01098. No impact or actual issue. I suggest you upgrade to 3.10s or later.
The "%FMANRP_ESS-4-FULLVAI:" is due to a RADIUS attribute "Framed-Compression" that is set to Van-Jacobsen-TCP-IP. This will cause the ASR1K to use Full Virtual Access Interface. Unfortunately this is not supported on the ASR 1000 as is. For a workaround look at the following guide:
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...