Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WCCP redirection for non standard ports

Hi,

I have a WAN accelerator which communicates with the router using WCCP v2.

In addition to "http" traffic I need to redirect traffic arriving on other application ports.

I'm believe using an extended ACL will check only for source and destination IP address.

1. Could anyone confirm this?

2. Is there an alternate way of acheiving this?

Any inputs would be highly appreciated.

Pankaj

2 REPLIES
New Member

Re: WCCP redirection for non standard ports

Hi

Extended Acls will also check for sepcific protocols i.e tcp, udp, igmp,icmp,rip,etc and again check for both source port and destination port numbers as you may wish to specify.

Hope this helps

cheers

paul

New Member

Re: WCCP redirection for non standard ports

Hi Paul,

thanks for your reply. I agree an extended ACL can match for source and destination ports.

I am refering to the use of extended ACLs in context with WCCP.

Here is a snapshot of recommended config -

Router(config)# ip wccp web-cache redirect-list 120

Router(config)# access-list 120 deny tcp host 10.1.1.1 any

Router(config)# access-list 120 deny tcp any host 12.1.1.1

Router(config)# access-list 120 permit ip any any

For complete configuration guide -

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/ffun_c/fcfprt3/fcf018.htm#wp1001150

296
Views
2
Helpful
2
Replies
CreatePlease login to create content