Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WCCP with multicast for dynamic services

I'm trying to configure WCCP forwarding of HTTPS traffic with a multicast group.  The group-listen configuration option doesn't seem to be taking effect for numeric service_ids.  To eliminate problems with the web-caches I tried ping-testing, and the routers respond on any address configured with web-cache, but none configured with any numeric service ID.  I've searched the support pages and release notes, but have found no mention of this behavior for our test routers (800 series running 12.4(22)YB) or any other router/IOS combination.

example config:

ip wccp web-cache group-address password password

ip wccp 70 group-address password password

In the above configuration pings to are responded to by the router's unicast address, where pings to are not responded to at all.  WCCP in all-unicast mode works with HTTP and HTTPS, and with HTTP in multicast.   I can update the router's firmware if this will help, but since there is no mention of this issue in any documentation I don't want to just randomly mess with my firmware in hope of a solution.  Has anyone seen this behavior before?  Found a solution?


Everyone's tags (3)
New Member

Re: WCCP with multicast for dynamic services

OK, so after I ask for help I find the obvious solution. 

I'd added ip wccp 70 group-listen on the wrong interface. 

Working config, for the next guy to fall off this bridge:


ip wccp web-cache group-address a.b.c.d password password

ip wccp 70 group-address a.b.c.d password password


interface TheCorrectInterface1
ip address x.x.x.x y.y.y.y
ip wccp web-cache redirect out
ip wccp web-cache group-listen
ip wccp 70 redirect out
ip wccp 70 group-listen