Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

weird router issue

I have a pair of 2621XM routers and with both of them whenever you enter a command in enable mode the output is delayed by a few seconds. But if I go into config mode and run the same command with the "do" attached to the front of it, the output comes up immediately. This seems to be true for all commands I have tried. "sh run" "sh ver", etc. Again, if I am in config mode and type "do sh run" or "do sh ver" there is no delay in the output. CPU has about 1% utilization. What is causing this?

2 REPLIES

Re: weird router issue

hi

Have you tried the usual reset techinique with one of the box and checked for any change in the performance ?

Also whats the exact ios code and the file name which you have installed in your boxes at present,may an upgrade to a recent GD version will also do a trick..

regds

New Member

Re: weird router issue

Hello,

Are you running any AAA - command authorization?

Regards,

James

90
Views
0
Helpful
2
Replies
CreatePlease to create content