Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

What commands can display IS-IS timers?

The "show run" or "show start" commands display IS-IS timer settings which have been specifically configured on a router.

Is there any other show or other commands that display the IS-IS timers such as the current value for the "hello interval", "hello multiplier" or the calculated "hold timer" and other such timers?

2 REPLIES
VIP Gold

Re: What commands can display IS-IS timers?

"sh clns" & "sh clns protocol" may be the commands that would give you what you are looking for.

Community Member

Re: What commands can display IS-IS timers?

The commands you identified provide exactly what I was looking for.

Thanks!!

122
Views
5
Helpful
2
Replies
CreatePlease to create content