Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

What is Defect status mean from an ATM circuit?

my Atm port is down/down, is that mear the card has problem?

On my atm card, the defect status, LOS ( loss of signal, LOF (loss of frame ), is that indicating a physical atm card problem?

Modem Status: Showtime (DMTDSL_DLOAD_1)

DSL Mode: ITU G.992.1 (G.DMT) Annex A

ITU STD NUM: 0x01 0x1

Vendor ID: 'STMI' ' '

Vendor Specific: 0x0000 0x0000

Vendor Country: 0x0F 0x00

Capacity Used: 24% 72%

Noise Margin: -9.5 dB 6.0 dB

Output Power: 1.0 dBm 5.0 dBm

Attenuation: 10.0 dB 6.0 dB

Defect Status: LOS LOF LCDf LOM LOS LOF LCDf

Last Fail Code: None

Watchdog Counter: 0x79

Watchdog Resets: 0

Selftest Result: 0x00

Subfunction: 0x00

Interrupts: 118646 (0 spurious)

PHY Access Err: 0

Activations: 1

LED Status: OFF

LED On Time: 0

LED Off Time: 0

Init FW: init_AMR-R-2.5.042_no_bist.bin

Operation FW: AMR-R-2.5.042.bin

FW Source: embedded

FW Version: 2.5.42

Interleave Fast Interleave Fast

Speed (kbps): 0 2528 0 640

Cells: 0 35368625 0 2093775741

Reed-Solomon EC: 0 0 217 229

CRC Errors: 0 433 190 199

Header Errors: 0 5 177 200

Total BER: 0E-0 0E-0

Leakage Average BER: 0E-0 2E-0

1 REPLY
Hall of Fame Super Gold

Re: What is Defect status mean from an ATM circuit?

Was the circuit working previously?

What you see indicates a problem on the ISP side where ADSL is up but no circuit is working. So you need to log a ticket with them.

If you want to be the safe side, update your ADSL FW from:

ftp://ftp.cisco.com/pub/access/800

The one you want is 3.010 or later.

hope this helps, please rate post if it does!

537
Views
0
Helpful
1
Replies
CreatePlease to create content