I've heard about RIP, IGRP, EIGRP, OSPF, BGP, IS-IS and FRAME RELAY routing but never heard about round robin routing. I've had google about this but not come up with anything related. I would appreciate if anyone could explain what is round robin routing.
we can speak of round robin forwarding that is when multiple paths exist to reach a destination and per packet load balancing is used.
So round robin routing can be seen as process switching of packets.
Recent CEF implementations allow to perform per packet load balancing without a need to disable CEF (that is forwearding optimization technique used on Cisco routers and multilayer switches in SW on the first ones with the help of dedicated hardware on the second ones )
Standard CEF use per flow load balancing: given a flow with a specific SA and specific IP DA the same path is used for all packets classified on this flow.
per packet load balancing sends the subsequent packets of the same flow ( IP SA, IP DA) on the different paths and this is a round robin packet forwarding.
Then, in other contexts like server load balancing again round robin load balancing can be used in this case each new client TCP connection to the virtual IP address is "routed" to a different real server.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...