Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

What is the IPSec throughput of Cisco 3945 / 3925 routers?

Hi,

I want to know about IPSec (3DES/AES) throughput of Cisco 3945 / 3925 routers? I read about diffrent IPSec throughput values of Cisco 3900 series routers but there is no official site or document claiming about throughput. I got IPSec throughput information about other Cisco routers but not about Cisco 3945.Can someone provide some official documentation about same?

As some Cisco router vendor says that it is similar as Cisco 3800 series routers but these routers gives very low IPSec throughput around 210Mbps.


Thanks!

6 REPLIES
Hall of Fame Super Gold

Re: What is the IPSec throughput of Cisco 3945 / 3925 routers?

The throughput of a 3925 is 426.49mb and 3945 is 502.78mb (un-encrypted).  Cut the figure in half and that should give you encrypted throughput values.

VIP Super Bronze

Re: What is the IPSec throughput of Cisco 3945 / 3925 routers?

Hi,

For the 3945, IPSec throughput is 278MB and this number is not exceed 75% of the CPU. For the 3925 it is 223MB.

HTH

Reza

New Member

Re: What is the IPSec throughput of Cisco 3945 / 3925 routers?

Hi Reza,

Thanks for the information. Is there any official documents for this? Just for record.

VIP Super Bronze

Re: What is the IPSec throughput of Cisco 3945 / 3925 routers?

Unfortunately not.  I got these numbers unofficially from Cisco in an email, because I was comparing the 3800 with the new 3900 series for IPsec solution.

HTH

Reza

New Member

Reza, Is the figure

Reza, Is the figure unidirectional traffic or can I receive and send 223 Mbps at the same time on a 3925 ?

 

Regards

Umesh

Super Bronze

DisclaimerThe Author of this

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Normally, performance numbers are for aggregate volume.

 

I've attached a Cisco whitepaper that has ISR performance stats.

4281
Views
0
Helpful
6
Replies
CreatePlease login to create content