While the weight might have to meanings, the first is the factor that might be used to weight a parameter in the cost equation, or in BGP the weight is one of the Path Attributes used by BGP to influence the path selection (Its a local Cisco Proprietary attribute).
Look the routing protocols use the cost (or metric) to choose the best path from multiple paths to the same destination (the lower the cost the preferable the path), while the weight is a factor that can used to influence the effectiveness of a certain parameter in the equation used to calculate the cost (for example the K values used in EIGRP metric calculation can be thought as like weights per the metric parameters which are, bw, delay, ...).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...