Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Whats wrong with this RIP Configuration?

I am attaching the packet tracer file "Wrong Rip.pkt", in which i have configured networks as in the pic http://i.lulzimg.com/7c8a2d69de.png , The problem is when i remove the network 10.1.4.0 from the scene, everything works perfectly i.e each router can communicate with each other but when its in the design router networks unable to talk... What am i doing wrong???

Everyone's tags (1)
5 REPLIES
Purple

Whats wrong with this RIP Configuration?

Hi,

for VLSM support and discontiguous networks like in your topology you must use RIP v2 and disable auto-summary.

on all routers:

conf t

router rip

ver 2

no auto

do clear ip route *

then verify all the networks are in the routing table: sh ip route rip

Regards.

Alain

Don't forget to rate helpful posts.
New Member

Whats wrong with this RIP Configuration?

I understand this could be problem of Discontinous network, but how it is supposed to be VLSM??

Purple

Whats wrong with this RIP Configuration?

Hi,

Yep you're right the mask is /24 everywhere , I answered too fast for the VLSM thing.

Regards..

Alain

Don't forget to rate helpful posts.
New Member

Whats wrong with this RIP Configuration?

Thanks..i will read about discontinous networks then..

Purple

Whats wrong with this RIP Configuration?

Hi,

Don't forget to rate helpful posts and mark the thread as solved if your problem is resolved.

Regards.

Alain

Don't forget to rate helpful posts.
555
Views
0
Helpful
5
Replies