wait about 5-10 minutes and run "show cellular 0/3/0 all" to see the current version.
Another tip: for troubleshooting or whatnot you can't reload a cell card manually. The microcode upgrade reloads the card for you, but under normal circumstances you cannot reload the card (ie. hw-mod reload etc). With a hidden cisco command you can enable this though:
test cellular 0/3/0 modem-power-cycle
just thought you might like to know
When you are done, remove the service internal from the config.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...