Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Whole Stack Neighbor problem

Hi,

I have 7 numbers of 3750 Cisco Switch, they all are part of single stack. I found, there was flapping in the stack ports of Sw-3 (port-2) and Sw-4(port-1) which are directly connected with stack cable.

I have replaced the stack cable with new one, but now whole stack is flapping. Please help, I have attached the log below.

3730741: Jan  6 00:21:34.368: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 2 Switch3 has changed to state UP
3730742: Jan  6 00:21:35.291: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 1 Switch 4 has changed to state UP
3730743: Jan  6 00:21:36.382: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 2 Switch 3 has changed to state DOWN
3730744: Jan  6 00:21:37.304: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 1 Switch4 has changed to state DOWN
3730745: Jan  6 00:21:38.319: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 1 Switch 4 has changed to state UP

STACK#sh switch neighbor
  Switch #    Port 1       Port 2
  --------    ------       ------
      1        None          None
      2         1             3
      3         2            None
      4        None          None
      5         4             6
      6        None          None
      7        None           1


STACK#sh switch
Switch/Stack Mac Address : 0011.bbf1.4780
                                           H/W   Current
Switch#  Role   Mac Address     Priority Version  State
----------------------------------------------------------
*1       Master 0011.bbf1.4780     15     0       Ready
2       Member 0017.9409.4600     13     0       Ready
3       Member 0012.4347.0800     11     0       Ready
4       Member 0017.5ac4.2c00     9      0       Ready
5       Member 0017.95a9.5600     7      0       Ready
6       Member 000f.f749.5580     5      0       Ready
7       Member 0017.957f.5c00     3      0       Ready

STACK#sh swit stack-ring sp

Stack Ring Speed        : 16G
Stack Ring Configuration: Half
Stack Ring Protocol     : StackWise

2 REPLIES
New Member

Re: Whole Stack Neighbor problem

Champoins, please help

VIP Super Bronze

Re: Whole Stack Neighbor problem

Hello Rupesh,

Please take a look at this document for troubleshooting your stack.

This type of flapping is usually caused by a bad stacking cable or a defective StackWise interface on a switch

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/troubleshooting/switch_stacks.html

HTH

Reza

575
Views
0
Helpful
2
Replies