While Colin is certainly correct in saying that not all cards have built-in DSUs, I believe that it is not the best answer in this case. Cisco sometimes implements the same functions on different cards in different ways. A customer of mine uses many 1841s with serial cards. Many of these cards do have the built in DSU, but there is no separate controller interface. Instead the controller commands are entered as service-module commands under the serial interface such as these:
service-module t1 remote-loopback payload v54
service-module t1 timeslots 1-24
These were taken from an 1841 with the WIC-1DSU-T1-V2 card. So in this case Cisco has implemented the controller functionality commands under the serial interface rather than implementing a separate controller interface.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...