Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Why "show ip route <ip>" shows route, but I can't ping device?

Hi folks, imagine from a router name 'NAP', I do 'show ip route CRA' and I see the routing table info right there to CRA. Then I attempt to ping CRA and it times out.

If I go to CRA, I can ping NAP successfully.

I know already that if I do redistribution on edge routers PE2 and GWA, I can get to ping one another just fine.

So my question is really why a particular route appears on show ip route, but I can't ping it?

Please find attached detailed diagram and output for routers involved.

4 REPLIES
New Member

Re: Why "show ip route <ip>" shows route, but I can't ping devic

Here is the attachment.

Bronze

Re: Why "show ip route <ip>" shows route, but I can't ping devic

Destination router must have route for source address(interface from where ping is sourced) in order for it to respond. So in your case one of the reason for ping failure is that CRA router may not have route for the interface of NAP router from where you are sourcing your ping.

Re: Why "show ip route <ip>" shows route, but I can't ping devic

ACL's.

Re: Why "show ip route <ip>" shows route, but I can't ping devic

test

252
Views
0
Helpful
4
Replies