why want our 2921 router running C2900-UniversalK9-mz SPA.152-4.m3 IOS configured IPsec establish IPsec connections with our other routers running IPsec?
This is a new router to our numerus WAN locations running IPsec. When the Cisco 2921 router would not establish an IPsec connection with our other sites we fell back to a 2851 router running adventerprise IOS which worked fine.
Is there a differance in how to configure IPsec with the Universal IOS than a advenerprise IOS? If so what?
You have not given us much information to work with here. While there may be some differences in configuration in 15.2(4) as compared to the code on your 2851 I am not aware of anything that would prevent IPSec from running, other than the possibility that your new router may not have the correct license to activate IPSec. If you are sure that the new router did have the correct licenses activated then I suggest that you provide some details of how the new router was configured and perhaps some debug output as the router was attempting to establish the IPSec connection.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...