04-22-2009 06:22 AM - edited 03-04-2019 04:28 AM
I have a 3845 running 12.4.13a which I want to upgrade to 12.4.24.
After upgrade one of the interface that is configured for frame relay doesn't work anymore.
The interface configuration is:
interface Serial0/0/0
bandwidth 128
no ip address
encapsulation frame-relay
no ip mroute-cache
logging event subif-link-status
logging event dlci-status-change
no fair-queue
service-module t1 timeslots 1-4
service-module t1 remote-alarm-enable
frame-relay traffic-shaping
After the router reloads in 12.4.24 I get this errors in the log
Apr 22 13:39:33.525: %SERVICE_MODULE-4-WICNOTREADY: Unit Serial0/0/0 not ready for next command -Traceback= 0x61202820 0x60549704 0x605497B4 0x6054A458 0x605410F0 0x60547914 0x60548C58 0x60545D30 0x61243728 0x6125FA10 0x625E8D20 0x625EC350 0x6223EBC0 0x6223EBA4
Apr 22 13:39:33.525: wait_ft1_wic_mailbox failed 4
In fact is the "service-module t1 timeslots" commands that can not be executed and the router throws that error.
I tested this behaviour on two 3845s and the result is the same.
Is this a bug or is an workaround for it?
Thanks,
Florin
04-22-2009 06:43 AM
Florin,
I suggest you open a TAC case or revert back to a previous IOS version.
What triggered the IOS upgrade?
__
Edison.
04-22-2009 06:49 AM
Thanks for your post I will open a TAC case.
Florin
08-12-2012 11:00 AM
Came across this discussion looking to resolve the same issue. This is an old thread but figured I would post the bug id for future users.
Regards,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: