Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WIC-1DSU-T1-V2 on 1841 Cisco Router configuration

I am having a issue with a WIC-1DSU-T1-V2 on 1841 Cisco Router. I am following guide lines on-line per a WIC-1DSU-T1 (without V2) which is according to cisci.com pdf/page is to be configured with service-module commands rather than controllers but I can't bring the status of the Serial 0/0/0 to come up. I am trying to bridge a point-to-point to the same type of interface and 1841 router on the other end. Can someone explain to me what I am missing please. I've tried the following:

Interface serial 0/0/0

service-module t1 clock source line

service-module t1 timeslots 1-24 speed 64

service-module t1 framing esf

service-module t1 linecode b8zs

ip address 192.168.1.1 255.255.255.248

encapsulation ppp

fair-que

no shutdown

but only the following saves or shows up after a "show run":

"interface Serial0/1/0

ip address 192.168.1.1 255.255.255.248

encapsulation ppp

fair-queue

service-module t1 timeslots 1-24"

and here is the full "show int"

#show int ser 0/1/0put errors, 0

MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation PPP, LCP Closed, loopback not set

Keepalive set (10 sec)

Last input never, output never, output hang never

Last clearing of "show interface" counters 00:17:25

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: weighted fair

Output queue: 0/1000/64/0 (size/max total/threshold/drops)

Conversations 0/0/256 (active/max active/max total)

Reserved Conversations 0/0 (allocated/max allocated)

Available Bandwidth 1152 kilobits/sec

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

0 packets output, 0 bytes, 0 underruns

0 output errors, 0 collisions, 36 interface resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions

DCD=down DSR=up DTR=up RTS=up CTS=down

Thank you.

1 REPLY
New Member

Re: WIC-1DSU-T1-V2 on 1841 Cisco Router configuration

PS never mind the 0/1/0 and 0/0/0 mix up in the above txt. This is because like I mentioned I am trying to bridge a point to point between two actually three routers...the third will support the incoming NIU. Thanks for your help/advise!

847
Views
0
Helpful
1
Replies
CreatePlease login to create content