Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WIC-1T

HI,

I am confusing which cable i have to choose for 1 port WAN interface,is RS-232 or V.35?

Thanks

8 REPLIES

Re: WIC-1T

Hi

What is the termination of your modem?its a V.35 or an RS-232?Dpending on that,the cable will be selected.

Pls give the make and part no of your modem...it will help us.

Regards

JD

Re: WIC-1T

This is not related to your WIC-1T. It rather depends on the type of connection you have:

On the WIC-side, all connectors are the same but you need to order the correct cable for your modem/interface.

You should check with the provider of the leased line which interface will be used.

Regards,

Leo

New Member

Re: WIC-1T

The router will connect to 1.5Mbps lease line.

Re: WIC-1T

Hi

Can u give the modem make and part no?

Regards

JD

Re: WIC-1T

That still doesn't say anything about the interface. It is likely to be either X21 or V35 but as I stated previously, you will have to ask the provider about this.

Regards,

Leo

New Member

Re: WIC-1T

but the modem is provide by the ISP,we have to ask from them?

Re: WIC-1T

Hi

Yes you have to ask them.they will be doing their part by terminating their part...you have to do and start from there.

Regards

JD

New Member

Re: WIC-1T

That all depends which device you want to connect with. Like, if you want to connect with a Radio Modem, you probably want V.35 DTE. For a DXX connection, many vendors use RS232. Consult with your Service Provider or the Equipment manual.

247
Views
0
Helpful
8
Replies
CreatePlease login to create content