Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WIC-2A/S and 1841 router

I was wondering whether I could use WIC-2A/S into my new 1841 router . Are they compatible .

Thanks

  • WAN Routing and Switching
4 REPLIES

Re: WIC-2A/S and 1841 router

New Member

Re: WIC-2A/S and 1841 router

Hi samtiano2001

the router should be supported the WIC-2A/S

card

http://www.cisco.com/en/US/prod/collateral/routers/ps5853/product_data_sheet0900aecd8016a59b.html

thanks & rEgards

andy

Re: WIC-2A/S and 1841 router

Hi Samtiano,

WIC 2-port asynchronous/synchronous serial WAN interface card is listed for support the said platfrom. URL:http://www.cisco.com/en/US/prod/collateral/routers/ps5853/product_data_sheet0900aecd8016a59b.html

As per Cisco:

The dual-serial port WAN Interface Card (WIC-2A/S) provides higher levels of serial port density for a single WIC and is supported on the Cisco 1700, 2600, and 3600 series. The low serial speed WIC-2A/S supports up to 128 Kbps synchronous or 115.2 Kbps asynchronous serial links. Each port on a WIC is a different physical interface and can support different protocols such as Point-to-Point Protocol (PPP) or Frame Relay and Data Terminal Equipment/Data Communications Equipment (DTE/DCE). This WIC supports mixed asynchronous and synchronous operation on a single card as well.

These dual-serial port WICs feature Cisco's new, compact, Smart Serial connectors to support a wide variety of electrical interfaces when used with the appropriate transition cable. This includes: V.35, RS-232, RS-449, RS-530, RS-530A in male and female versions for both DTE and DCE devices. This feature provides easy configuration and reconfiguration as network requirements change, without the need of purchasing a different serial interface card.

But its not listed with URL:

http://www.cisco.com/warp/public/107/wic-2as.shtml

Thanks Goutam

Re: WIC-2A/S and 1841 router

Hi,

WIC-2A/S is supported on 1841 router.

Min. IOS requirement - 12.3(8)T4.

-> Sushil

612
Views
0
Helpful
4
Replies