So this WIC is supposed to support 8mb per channel when inserted directly into the onboard WIC slot of a 3845. When I run 2mb it runs clean w/ no problems but as soon as we try to pump it up over 2 mb, say 3mb, I get errors on the line and the line protocol subsequently drops. We are using the smart cable terminated to RS530 cable which is having no problem handling greater bandwidth on other applications here. I did notice in the WIC-2T specs it states 8mb dedicated up to 6 ports.... If I have 8 ports installed on one router will it force it down to 2mb per port? Does it matter that only 3 other ports are enabled? is there something else I might be missing? Any help is appreciated!
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...