Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WIC and HWIC in a Multilink

I have a current T-1 running on a WIC-1DSU-T1-V2. I am planning on getting a second T from the carrier for a mutlilink connection. Any problem mixing the current card with a HWIC-1DSU-T1 ?

I noticed the WIC is going EOL

1 ACCEPTED SOLUTION

Accepted Solutions

Re: WIC and HWIC in a Multilink

BRIAN,

Q. How are these HWICs different from WIC-1DSU-T1-V2, WIC-1T, WIC-2T, and WIC-2A/S?

A. The new HWICs have the same software features as the older WICs. The HWIC-1T has a Cisco Smart Serial connector where the WIC-1T had a DB-60 connector. The front-end NEBS protection of HWIC-1DSU-T1 has also been improved.

Please check out this link.

http://www.cisco.com/en/US/prod/collateral/modules/ps5949/qa_c67-490366.html

You should be fine as long as Box can recognize both interfaces. Then go configure multilink functions.

HTH,

Toshi

2 REPLIES
Hall of Fame Super Gold

Re: WIC and HWIC in a Multilink

No, there should not be a problem.

Re: WIC and HWIC in a Multilink

BRIAN,

Q. How are these HWICs different from WIC-1DSU-T1-V2, WIC-1T, WIC-2T, and WIC-2A/S?

A. The new HWICs have the same software features as the older WICs. The HWIC-1T has a Cisco Smart Serial connector where the WIC-1T had a DB-60 connector. The front-end NEBS protection of HWIC-1DSU-T1 has also been improved.

Please check out this link.

http://www.cisco.com/en/US/prod/collateral/modules/ps5949/qa_c67-490366.html

You should be fine as long as Box can recognize both interfaces. Then go configure multilink functions.

HTH,

Toshi

510
Views
0
Helpful
2
Replies