WIC2T and MLLN

Cisco Support Community

Community Member

‎05-23-2008 06:49 AM

hi,

When i connect 1700 WIC2t to my MLLN circuit, the circuit is comming up on hdlc and pp as well.

But when i budle it with multilink (PP multilink group) it's going down.

Configuration is fine and very less at both ends.

the circuit is BSNL MLLN.

in the same E1 multiple customer routers are working fine with same config.

I have seen some posts and found WIC 2t having issues with MLLN.

any guidance will be helpfule.

Labels:

WAN Routing and Switching

3 REPLIES

Hall of Fame Super Gold

‎05-23-2008 09:32 AM

You are trying multilink on a single circuit? What's for ?

Community Member

‎05-23-2008 09:51 AM

im using crypto tunnels and voice traffic , which are well supported by multilink interface at both sides.

Community Member

‎05-26-2008 09:31 PM

any insputs?

Latest Documents

Cisco ESW-520-24P Switch Configuration

Created by Kevin DeMott on 04-19-2018 01:49 PM

We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des... view more

BGP Conditional Advertisement Feature

Created by Dennis Mink on 03-06-2018 09:17 PM

This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does "Th... view more

le router cisco 887 VA-K9 ne diffuse pas les adresses IP au reseau local

Created by mustiman on 03-05-2018 05:53 AM

Question bonjours j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m... view more