Will a WS-C3550-24-PWR Switch do routing and 758 VLAN Tagging
Guys ... decided to start a new thread since the old topic of "Port Speed" did not apply anymore.
Until I can replace my router, I'd like to use my Cisco WS-C3550-24-PWR switch to do routing. My upstream ISP provided me with a /23 IP block and they are using VLAN 758 tagging. They installed their own Cisco switch in my NOC -- so I'd like to connect port 24 of my switch (making it the WAN port) to their switch and use the other ports as LAN ports. My switch software version is 12.1(14)EA1a).
To recap: I'd like to use port 24 on my 3550 switch as the WAN port using VLAN 758 tagging and use the other 23 ports as LAN ports using the /23 IP block from my ISP, as well as using private IPs (172. 20.54.0/23). I'd like to do subnetting on both the private and public IPs.
Can I configure this 3550 switch to do this?
If this helps -- I can enter "IP Routing" in Conft Term mode.
Any docs to reference would be greatly appreciated!
Can this switch handle a 30Mbps upstream connection (WAN port)?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...