Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLAN DMZ on Cisco 877

Hello,

I have a pretty basic setup with an cisco 877 for routing our lan over adsl. Now we want to have an public wlan available in our shop. I think I need to set-up an 2nd vlan, and use that with Eth3 to hook up the accesspoint. Can anyone explain me the steps to create an dmz set-up on the 877 for this? I'm only beginner in cisco configs.

1 REPLY
Silver

Re: WLAN DMZ on Cisco 877

The connection to the Internet is over a serial line. Ethernet 0 is connected to the internal network (a single LAN). Ethernet 1 is connected to a DMZ network, which has a single node used to provide services to the outside world. The ISP has assigned the company the netblock 192.168.27.0/24. This is equally split between the DMZ and the internal LAN with subnet mask 255.255.255.128.

For further information about configure DMZ interface click this link.

http://www.cisco.com/en/US/products/sw/secursw/ps1018/products_configuration_example09186a0080094111.shtml

427
Views
2
Helpful
1
Replies