Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WLC dhcp config help. Registering in TWO scopes?

I have WLC setup with two SSID's. When the clients register, they first get a DHCP IP from the scope that the managment port is in, then a second registion comes from the scope that the wireless vlan is in. I can't seem to figure out why this is happening. I have DHCP proxy disabled on the WLC, and helper-addresses setup on the router interfaces. None of the wlan's have any custom dhcp settings.

Any idea where I start?

  • WAN Routing and Switching
152
Views
0
Helpful
0
Replies
This widget could not be displayed.