I have a new WRT54GH and I need to configure it to work serving the address of the principal router (another Cisco router)
I can't see the option to set the WRT54GH like repeater. Really exist this function for this model?
Searching the web I found two ways to try it.
1rs -- Set a group of parameters like enable DHCP server inside same IP family (take a free range) and using Client and gateway mode (advanced routing, etc) But this WRT54GH stop traffic when I serve inside same IP family (I supose to prevent conflict)
2nd -- Crack the firmware overwriting with a alternative "generic" firmware. By doing it, the other webconsole let me configure the infrastructure mode.
Anyway, this WRT54GH is not usefull with current oem Cisco configuration.
Before proceding, is there a way, patch or mechanism to get infrastructure mode?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...