Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WS-C3550-48-SMI ERROS

I've been monitoring the 2 switchs WS-C3550-48-SMI

over the last couple weeks. Although there are no logs that give evidence, it appears there is something not quite right with these switches. From a monitoring tool that I have I can see interface resets on the Gigabit uplink port for some time now. There is a line under performance summary that states the number of state changes since midnight last night. I do not see this on the interface statistics (under carrier resets) but I have been notified of some complaints about poor performance on these switches. I can see the links are not overloaded so there must be a good explanation somewhere else up to and including something not related to the network

Please suggest me on the same

Regds

Adhi

3 REPLIES
Hall of Fame Super Bronze

Re: WS-C3550-48-SMI ERROS

Adhi,

Can you please provide the output you are seeing?

Perhaps you are experiencing duplex-mismatch in the configuration between the switch and another device or faulty cable.

__

Edison.

New Member

Re: WS-C3550-48-SMI ERROS

HI

Thanks very much for reply

output is below

GigabitEthernet0/1 is up, line protocol is up (connected)

Hardware is Gigabit Ethernet, address is 000e.38e4.5c31 (bia 000e.38e4.5c31)

MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive not set

Full-duplex, 1000Mb/s, link type is auto, media type is 1000BaseSX

input flow-control is off, output flow-control is off

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:00, output 00:00:11, output hang never

Last clearing of "show interface" counters never

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue: 0/40 (size/max)

5 minute input rate 273000 bits/sec, 462 packets/sec

5 minute output rate 4000 bits/sec, 4 packets/sec

34050999 packets input, 10981338 bytes, 0 no buffer

Received 30924958 broadcasts (0 multicasts)

0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog, 23671238 multicast, 0 pause input

0 input packets with dribble condition detected

3115507 packets output, 859866121 bytes, 0 underruns

0 output errors, 0 collisions, 1 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier, 0 PAUSE output

0 output buffer failures, 0 output buffers swapped out

i have cheked there is no duplexmatch could you suggest me

regd

Adhi

Hall of Fame Super Bronze

Re: WS-C3550-48-SMI ERROS

Adhi,

Based on the output provided, I don't see anything wrong with the switchport. I'm unsure what mechanisms your NMS tool uses to determine health on the switch but this interface is in good shape.

Regards,

__

Edison.

105
Views
0
Helpful
3
Replies