Thank you Haihua - we will give this a shot. My fear is that that the root password has been changed as well. Does issuing the hw-module module slot_number reset cf:1 command from the Supervisor engine reset the Guard module root password to "cisco"?
Haihua - this process still does not seem to reset the root password. After performing the "clear ap password" and reset sequence, the root password is still not defaulted. Any other ideas or suggestions? Thank you in advance!
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...