07-23-2012 06:07 AM - edited 03-04-2019 05:02 PM
Hi dears.
i installed new WS-X6516A on 6500 series switch. the module front panel led is off and the status is power down.
how i troubshouting this module? is this physical problem? or must I write any command to active the module?
please help me.
thank you advice.
07-23-2012 07:51 AM
Hello Teymur,
check
show environment
show environment power
or show power
to see if there is available power to power on the module
Hope to help
Giuseppe
07-23-2012 09:43 PM
Dear Giuseppe
. i did show command and there have a power. what i check next?
07-23-2012 10:42 PM
i installed new WS-X6516A on 6500 series switch. the module front panel led is off and the status is power down.
Did you ENABLE the power to the module? Command: power enable module
Can you please post the output to the command "sh log"?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: