Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
Community Member

X.21 configuration issue

Hi All

I am trying to open a telnet connection on port 1998 to a Cisco 876 router (C870-ADVENTERPRISEK9-M) on the same network - 'connect failed'

The source device is running W2003 server.

The reason for my test, is to facilitate connectivity between 2 devices running ODEX software. Initial tests, via an OFTP session to the remote host across an ISDN connection failed.

Router config: -

x25 routing

interface Dialer1

no ip address

encapsulation x25

dialer pool 1

dialer string xxxxxxxxxxx

dialer max-call 1

dialer-group 1

x25 address xxxxxxxxxxx

x25 htc 1

x25 win 7

x25 wout 7

x25 facility windowsize 7 7

x25 facility packetsize 128 128

x25 route xxxxxxxxxxx interface Dialer1

Can anyone help?

Many thanks in advance

Hall of Fame Super Gold

Re: X.21 configuration issue

Are you trying to do X.25 over ISDN to a thir-party device with protocol translation ?

Or what are you trying to do? Please clarify the full network topology.

If it is the above, you would also need some sort of protocol translation commands to the TCP connection to the server. Some config example (more can apply):

Hope this helps, please rate post if it does!

CreatePlease to create content