Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

X.21 @ WIC-1T Back to Back

Hi,

I want to connect two Routers with a WIC-1T over X21 bach-to-back. Does this work with a CAB-SS-X21FC and a CAB-SS-X21MT for testing pupose? I know that will have to configure the clockrate on the DCE side.

Thanks,

Thomas

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: X.21 @ WIC-1T Back to Back

Tomas,

The WIC-1T has a DB60 interface. The cables you listed use the smart serial connector so they will not work. The following cables should work.

DB15F X21 to DB60 CISCO Cable: CAB-X21FC

DB15M X21 to DB60 CISCO Cable: CAB-X21MT

3 REPLIES
Silver

Re: X.21 @ WIC-1T Back to Back

Hi Thomas

I am not too sure of the cable labels you mentioned in your post. But if you have an X21 DTE cable and an X21 DCE cable, and you connect the two DB15 ends together, then yes, this will work to connect two routers together.

I actually have a number of different DCE/DTE connections (X21, RS232,V35, RS449) in my home lab along with the DB60/DB60 back to back cables and they all work, no problem.

HTH

Best Regards,

Michael

New Member

Re: X.21 @ WIC-1T Back to Back

Tomas,

The WIC-1T has a DB60 interface. The cables you listed use the smart serial connector so they will not work. The following cables should work.

DB15F X21 to DB60 CISCO Cable: CAB-X21FC

DB15M X21 to DB60 CISCO Cable: CAB-X21MT

New Member

Re: X.21 @ WIC-1T Back to Back

I Ment the CAB-X21FC and the CAB-X21FC (without the -SS-) so i will try with them

Thank You

770
Views
0
Helpful
3
Replies