03-11-2010 03:12 AM - edited 03-04-2019 07:47 AM
please i want to run a debug on a serial interface on cisco router.please what are the commands to issue and i do i obtain the debug outputs for analysis.
i anticipated urgent asistance
thanks a a lot
03-11-2010 03:24 AM
Hello Olankule,
if you are in a telnet /SSH session you need:
termina monitor
you need privilege level 15 (enable)
debug is activated per type not on specific interfaces generally speaking
in your case
debug x25 ?
all Show all X.25 traffic (default)
annexg X.25 over Frame-Relay (Annex-G) Events
aodi Always On/Direct ISDN (PPP over X.25) events
cmns Show only CMNS traffic
events Show X.25 traffic without normal Data and RR packets
interface Show X.25 or CMNS traffic on one interface
only Show only X.25 traffic
vc X.25 traffic across a specific virtual circuit
xot Show only XOT (X.25-Over-TCP) traffic
you can use deb x25 interface serial x/y
advice:
have a second telnet session to device
enable logging on telnet/SSH first session to save to a file
Hope to help
Giuseppe
03-11-2010 03:46 AM
i anticipated urgent asistance
Please do not solicit for timely support on a freely contributed forum like this.
If you need guaranteed 24/7 support, buy a support contract.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide