Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

X25 Call , then file transfer

Hi,

I have an x25 call established between two peers through PAD over XOT. Assuming that i would want a packet transfer to be exchanged between both these peers (two end hosts connected to routers). Can i achieve this through regular ftp?

Thanks!

4 REPLIES
New Member

Re: X25 Call , then file transfer

Hello echelon,

Maybe what you need is X.25 and TCP/IP combination. I don't know if you are already using it. But, you can use the x25 link to pass your ftp traffic. Try this.

---R1

int s0

enc x25

x25 address 123456

x25 map ip 10.10.10.2 654321

ip address 10.10.10.1 255.255.255.252

!

ip route R2-SUBNET 10.10.10.2

---R2

int s0

enc x25

x25 address 654321

x25 map ip 10.10.10.1 123456

ip address 10.10.10.2 255.255.255.252

!

ip route R1-SUBNET 10.10.10.1

New Member

Re: X25 Call , then file transfer

thank you for replying!

I have attached a diagram of what i'm trying to achieve.

Essentially, i would like to have X25 calls generated between WAN POP A and WAN POP B. Once that is verified working. I would like to have WAN POP B migrate to Core 2. This will help me validate impacts on X25 during migration.

I was hoping to accomplish this by first,setting up an FTP transfer between both X25 PEERs and have that running. Once that is active, i will initiate the migration.

New Member

Re: X25 Call , then file transfer

Hi echelon,

I didn't understand the relation between the FTP and the X25 migratration. Can you provide more details?

PRoque

New Member

Re: X25 Call , then file transfer

thank you for taking the time to reply.

What i was hoping to achieve was

1) ensure an x25 call is active between both peers (i.e WAN POP A and B)

2) Ensure that there is packet transfer between both peers.

3) initiate the migration at the core end to see the effects it has on the x25 call/packet transfer

I will have two linux hosts plugged in at the endpoints of both the WAN POP Routers to ensure the packet transfer over X25.

I will have to run the same test again but this time, over an asynchronous serial interface and evaluate the impacts.

Any thoughts on this pls?

104
Views
0
Helpful
4
Replies