Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

x25 connection problem

hi, all

I have an x25 wan connection

I have a 1700 serie router

I configure the interface serial 0

but the command show interface serial 0

affich:

Serial 0 is up, line protocol is down

1 REPLY
New Member

Re: x25 connection problem

hi,

is the enddevice directly connected to a cisco router or to a x25 switch?

if it is connected directly - try this:

int s0

enc x25 dce

x25 htc 10 (it depends)

x25 address 1234

x25 win 7

x25 wout 7

perhaps you need a clocrate - in the case if the enddevice is connected without a modem

clock rate 9600

!

if the enddevice is connected through a x25 switch you do not need "enc x25 dce".

instead this u will have to configure only "enc x25".

x25 has a kind of master/slave relationship.

if there is a x25 switch you do not need the dce statemant - this does the x25 switch.

dce in this case does NOT mean the layer 1 dce!!!

it is in layer 2 !

217
Views
0
Helpful
1
Replies
CreatePlease login to create content