cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
285
Views
1
Helpful
1
Replies

X25, issue with translate statements

echelon360
Level 1
Level 1

Hi all,

I'm trying to setup a packet flow between Host A and B using netperf but i am unable to generate the packet. I think i'm missing something with the translate statements. Please advice if the statements i have are not correct.

(pls reference diagram)

*DNS routing for X25

Router A

---------

TCP to X25

translate tcp 192.168.1.13 4000 x25 0404456368002

X25-TCP

translate x25 0404456368005 printer 192.168.1.1 port 4000

Router B

--------

TCP to X25

translate tcp 192.168.2.13 4000 x25 0404456368005

X25 to TCP

translate x25 0404456368002 printer tcp 192.168.2.1 port 4000

1 Reply 1

tstanik
Level 5
Level 5

Troubleshooting translation.

Certain show commands which allows you to view an analysis of show command output.

• show debug-enables you to display a variety of debug information, or to perform specific troubleshooting activities.

• telnet x.x.x.x -connects to computer systems on the Internet in prompt mode.

• pad 345-logs you on to a PAD.

• show x25 vc-displays information about active switched virtual circuits (SVCs), and permanent virtual circuits (PVCs) in privileged EXEC mode.

http://www.cisco.com/en/US/tech/tk713/tk730/technologies_configuration_example09186a0080094a46.shtml#test1

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: