02-23-2006 07:42 AM - edited 03-03-2019 11:50 AM
I changed baud rate for down loading Ios, but after changing the baud rate, router is not accessable on rommon mode.
what can i do. can any one help me
02-23-2006 07:47 AM
Hi
Try to change the baud rate in the console settings exactly to the baud which you set as Speed parameter for uploading the IOS.
Then you will be able to access the router,once you are done with the same do remember to change the same back to the normal speed(9600)..
regds
02-23-2006 09:20 PM
Hi
I have tried all solution . i set consol at the same baud rate but aftre the proedure router is not accessible.
how can i get back the router startup. ???
Is there any method that i get back the default setting of router.
Thankx for the reply.
02-24-2006 12:32 AM
Hi there,
If there is a config on the router and you have an IP address on an interface (ethernet), that is not shut down.... connect to this interface and telnet to the router to change the baud settings.
Hope it helps
Stephen
02-24-2006 12:44 AM
hi
If you are doing with either 2600 or 3600 you can check this link which help u to reset the same using jumpers..
http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008009433b.shtml
regds
02-24-2006 01:10 AM
Hi
Thanks for the reply.yes i have 2600,
but i have same problem with AS5300. i want to rerset the jumper. have any link for AS5300 to reset the jummer.
Thankx
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: