I am trying to convert a 6509 from mixed to IOS native mode and I screwed up. Now it only boots to rommon>. The bootflash is empty and I don't have a flash card (they are on order) above 20MB to handle the image which is 26MB.
I am trying to transfer via xmodem and it is not working. I have the console port set to 38400 as the default speed.
Whenever I try to transfer based on the recovery procedure on Cisco's site, I get either no response message(within hyper-terminal). See attached screen shot. You can see some of the previous console messages as well.
Bug ID CSCdr13160 has no detail information at this time. Please add to your watch group. Doing so will notify system administrators of your interest in this bug. Bug Toolkit can then notify you when changes occur.
Add x/ymodem support in rommon for IOS image booting
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.