Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

xmodem to recover 6500 issues

I am trying to convert a 6509 from mixed to IOS native mode and I screwed up. Now it only boots to rommon>. The bootflash is empty and I don't have a flash card (they are on order) above 20MB to handle the image which is 26MB.

I am trying to transfer via xmodem and it is not working. I have the console port set to 38400 as the default speed.

Whenever I try to transfer based on the recovery procedure on Cisco's site, I get either no response message(within hyper-terminal). See attached screen shot. You can see some of the previous console messages as well.

Any help would be appreciated.

Thanks

1 REPLY
New Member

Re: xmodem to recover 6500 issues

This is what the boot looks like, maybe this will help.

System Bootstrap, Version 7.1(1)

Copyright (c) 1994-2001 by cisco Systems, Inc.

*** Mistral Interrupt on line 2 ***

IO bus interrupt due to illegal addr, no ack, etc

PC = 0xbfc1234c, Cause = 0x1000, Status Reg = 0x30419003

ROM Monitor Can Not Recover From Exception

A Board Reset Is Issuedþ

System Bootstrap, Version 7.1(1)

Copyright (c) 1994-2001 by cisco Systems, Inc.

c6k_sup2 processor with 524288 Kbytes of main memory

Autoboot executing command: "boot bootflash:"

boot: cannot determine first file name on device "bootflash:"

System Bootstrap, Version 7.1(1)

Copyright (c) 1994-2001 by cisco Systems, Inc.

c6k_sup2 processor with 524288 Kbytes of main memory

rommon 1 >

785
Views
0
Helpful
1
Replies