Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

XOT Redundancy Timers

In the command

x25 route nri1 xot ip1 ip2

It tries the XOT connection to ip1 for 30 seconds and fails and then tries to ip2.

How can I do to change the 30 seconds period?.

1 REPLY
Silver

Re: XOT Redundancy Timers

By default the XOT connection is kept alive for 60 seconds and also based on keepalive retry count set.For changing this time the following commands can be used:

1)xot-keepalive-period seconds

seconds-the number of seconds for keepalives between Xot connections.60 seconds is default

2)xot-keepalive-tries count

count-represents the number of times the keepalive message should be sentt before dropping the connection.By default it is 4 times.

For more information about XOT timer configuration with examples refer the following URL:

http://www.cisco.com/en/US/docs/ios/12_3/wan/command/reference/wan_x1g.html#wp1033412

124
Views
0
Helpful
1
Replies
CreatePlease to create content