Cisco Active Directory Agent and Ironport WSA (S370)
I'm currently doing a trial run of IronPort. I have a S730 WSA in a lab environment. I have alot of experience with webfilters in general (Barracuda, Websense, Marshal8e6, etc) and most of those applications have some type of Active Directory agent for servers to feed a table of the domain usernames and associated IP's to the device. I see that Cisco has a similar application, Cisco Active Directory Agent and that it works with botht the ASA (for user based firewall) and with the IronPort WSA (http://www.cisco.com/en/US/docs/security/ibf/setup_guide/ibf10_overview.html). I have done a good bit of searching, but I cannot find anywhere how to configure the Ironport WSA to use the AD Agent from cisco. Does anyone have any experience with this?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...