I have succesfully upgraded Cisco WSA S160 from 7.5.0-833 to 7.5.2-118. Actually I am not really sure the version that I have upgraded. I was in a rush so I forgot to take notes during the update. Anyway, after the upgrade completed and device booted;
There is also a high chance that the appliance (the S160 specifically), did not reboot. Before the reboot, it needs to shut down services one by one. Not all services shut down tidly and the reboot never happens. If it still does not respond after a hard reset, it will likely need to be replaced. The S160 is end-of-life by the way.
I went to site and started a console connection successfully. I tried to restart and shutdown gracefully without luck. Then I shutdown and reboot the WSA from the power button. Everything is working right now. Upgrade is a success.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...