The error was generated by caracter 'é'. Avoid accents and special caracter in pac commentaries.
But problem is that if you have already uploaded the proxy.pac you won't be able to correct it. The Web appliance will prompt you an error. The only way we found is to manually modify the configuration file like in my post above.
Re: IronPort Web Security impossible edit proxy.pac
This is correct. There is a defect in version 7.5.1 that causes this behavior. High bit characters in PAC files that have been uploaded to the WSA will cause the application fault when trying to access it again. I have not tried the workaround method that Jfafinski mentioned.
Alternatively, you can open up a ticket with TAC and the TAC engineer will be able to use the Remote Access of the appliance to retrieve and delete the PAC file on the appliance.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...